Ich habe ein bestehendes nicht genutztes raid 1 auseinandergenommen und geloescht, doch beim erstellen eines neuen Raid1 bekomme ich folgende Meldung
Code:
mdadm: /dev/sdc appears to be part of a raid array:
level=raid0 devices=0 ctime=Thu Jan 1 01:00:00 1970
mdadm: partition table exists on /dev/sdc but will be lost or
meaningless after creating array
mdadm: Note: this array has metadata at the start and
may not be suitable as a boot device. If you plan to
store '/boot' on this device please ensure that
your boot-loader understands md/v1.x metadata, or use
--metadata=0.90
mdadm: /dev/sdd appears to be part of a raid array:
level=raid0 devices=0 ctime=Thu Jan 1 01:00:00 1970
mdadm: partition table exists on /dev/sdd but will be lost or
meaningless after creating array
mdadm: size set to 2930135488K
mdadm: automatically enabling write-intent bitmap on large array
Continue creating array? y
mdadm: unexpected failure opening /dev/md3000
Also bei beiden Platten
- level=raid0 devices=0 ctime=Thu Jan 1 01:00:00 1970
- mdadm --detail --scan
gibt kein Ergebniss zurueck
Code:
# mdadm -r /dev/sdc1
mdadm: /dev/sdc1 does not appear to be an md device
# mdadm -r /dev/sdd1
mdadm: /dev/sdd1 does not appear to be an md device
# mdadm -r /dev/sdd
mdadm: /dev/sdd does not appear to be an md device
# mdadm -r /dev/sdc
mdadm: /dev/sdc does not appear to be an md device
# mdadm -E /dev/sdc1
mdadm: No md superblock detected on /dev/sdc1.
# mdadm -E /dev/sdd1
mdadm: No md superblock detected on /dev/sdd1.
Was kann das sein?
Zweite Frage, kann ich statt der sdc/sdd auch UUIDs beim erstellen des Raid verwenden ?
Lesezeichen