ich brauch mal wieder eure Hilfe ....

System SuSE 9.3 / Parallel ZIP 100 / SCSI-HDD's

wenn ich ppa mit "modprobe ppa" starte, funzt das Zip einwandfrei.
wenn ich in YAST: [x] ppa in initrd laden aktiviere, kommst beim booten folgende Fehlermeldung:
Code:
<5>SCSI subsystem initialized
<4>ppa: Unknown symbol parport_register_device, st_info == 0x1
<4>ppa: Unknown symbol parport_register_driver, st_info == 0x1
<4>ppa: Unknown symbol parport_release, st_info == 0x1
<4>ppa: Unknown symbol parport_claim, st_info == 0x1
<4>ppa: Unknown symbol parport_unregister_device, st_info == 0x1
<4>ppa: Unknown symbol parport_unregister_driver, st_info == 0x1
Ich kann ppa nach dem einloggen aber ohne Probleme starten.

In der modprobe.conf ist ein Eintrag für Parallel Devices: Muss ich den auskommentieren?
Was muss ich für "frpw" eintragen ?

Code:
########################################################################
# For parallel port devices, uncomment the following two lines and
# change "frpw" to the protocol type you use
########################################################################

# install paride /sbin/modprobe --ignore-install paride && { /sbin/modprobe --ignore-install frpw; }
# remove paride { /sbin/modprobe -r --ignore-remove frpw; } ; /sbin/modprobe -r --ignore-remove paride
Und noch was unwichtigeres: Wann erscheint ein Laufwerk eigentlich im Arbeitsplatz (SuSE) ?

.... danke, Andy