timbo123
21.04.10, 10:03
Hallo,
ich habe ein Bonding-Interface (bond0) mit eth0 und eth2 laufen.
Jetzt möchte ich bond1 erstellen und auch über eth0 und eth2 laufen lassen.
ifcfg-eth0 sieht so aus:
DEVICE=eth0
BOOTPROTO=none
ONBOOT=yes
TYPE=Ethernet
UserCTL=no
MASTER=bond0
SLAVE=yes
DEVICE=eth2
BOOTPROTO=none
ONBOOT=yes
TYPE=Ethernet
UserCTL=no
MASTER=bond0
SLAVE=yes
habe jetzt mal ifcfg-eth0:0 erstellt:
DEVICE=eth0:0
ONBOOT=yes
MASTER=bond1
SLAVE=yes
habe jetzt mal ifcfg-eth2:0 erstellt:
DEVICE=eth2:0
ONBOOT=yes
MASTER=bond1
SLAVE=yes
ifcfg-bond0:
DEVICE=bond0
BOOTPROTO=none
UserCTL=no
BONDING_OPTS="mode=1 miimon=100 primary=eth0 updelay=45000"
ifcfg-bond1:
DEVICE=bond1
BOOTPROTO=none
UserCTL=no
BONDING_OPTS="mode=1 miimon=100 primary=eth2:0 updelay=45000"
Wenn ich jetzt bond1 starten will, krieg ich in dmesg folgende Meldung:
ADDRCONF(NETDEV_UP): bond1: link is not ready
bonding: bond1: Unable to set eth2:0 as primary slave as it is not a slave.
Jemand ne Idee, wie ich das hinkriegen kann? (verwendetes OS: CentOS 5.4)
ich habe ein Bonding-Interface (bond0) mit eth0 und eth2 laufen.
Jetzt möchte ich bond1 erstellen und auch über eth0 und eth2 laufen lassen.
ifcfg-eth0 sieht so aus:
DEVICE=eth0
BOOTPROTO=none
ONBOOT=yes
TYPE=Ethernet
UserCTL=no
MASTER=bond0
SLAVE=yes
DEVICE=eth2
BOOTPROTO=none
ONBOOT=yes
TYPE=Ethernet
UserCTL=no
MASTER=bond0
SLAVE=yes
habe jetzt mal ifcfg-eth0:0 erstellt:
DEVICE=eth0:0
ONBOOT=yes
MASTER=bond1
SLAVE=yes
habe jetzt mal ifcfg-eth2:0 erstellt:
DEVICE=eth2:0
ONBOOT=yes
MASTER=bond1
SLAVE=yes
ifcfg-bond0:
DEVICE=bond0
BOOTPROTO=none
UserCTL=no
BONDING_OPTS="mode=1 miimon=100 primary=eth0 updelay=45000"
ifcfg-bond1:
DEVICE=bond1
BOOTPROTO=none
UserCTL=no
BONDING_OPTS="mode=1 miimon=100 primary=eth2:0 updelay=45000"
Wenn ich jetzt bond1 starten will, krieg ich in dmesg folgende Meldung:
ADDRCONF(NETDEV_UP): bond1: link is not ready
bonding: bond1: Unable to set eth2:0 as primary slave as it is not a slave.
Jemand ne Idee, wie ich das hinkriegen kann? (verwendetes OS: CentOS 5.4)