Imagine
21.05.06, 20:10
Hallo,
ich habe auf meinem Laptop mit Debian Sarge eine WLAN-Karte D-Link DWL-G650+ installiert und zwar nach folgender Anleitung www.hauke-m.de/menue1/computer/acx100-acx111.html
Die Karte wird auch erkannt, iwconfig liefert
wlan0 IEEE 802.11b+/g+ ESSID:"IT-NETZWERK" Nickname:"acx v0.3.35"
Mode:Managed Frequency:2.412 GHz Access Point: Not-Associated
Bit Rate:1 Mb/s Tx-Power=15 dBm Sensitivity=1/3
Retry min limit:7 RTS thr:off
Encryption key:6147-3438-3477-7030-3400-0000-00 Security mode:open
Power Management:off
Link Quality=33/100 Signal level=6/100 Noise level=0/100
Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0
Tx excessive retries:0 Invalid misc:0 Missed beacon:0
In meiner /etc/network/interfaces steht folgender Eintrag drinnen
# The WLAN network interface (D-Link DWL-G650+)
auto wlan0
iface wlan0 inet dhcp
wireless-mode managed
wireless-keymode open
wireless-channel 1
wireless-essid IT-NETZWERK
wireless-key s:aG478ha098
dmesg liefert unter Anderem diese Meldungen
acx_i_timer: adev->status=3 (AUTHENTICATED)
association request reply timeout, giving up
acx_set_status(1):SCANNING
starting radio scan
acx: unknown EID 42 in mgmt frame at offset 69. IE: 2A 01 00
acx: unknown EID 47 in mgmt frame at offset 72. IE: 2F 01 00
acx: unknown EID 221 in mgmt frame at offset 81. IE: DD 06 00 10 18 02 00 05
acx: unknown EID 221 in mgmt frame at offset 89. IE: DD 18 00 50 F2 01 01 00 00 50 F2 02 01 00 00 50
F2 02 01 00 00 50 F2 02 00 00
acx: unknown EID 42 in mgmt frame at offset 69. IE: 2A 01 00
acx: unknown EID 47 in mgmt frame at offset 72. IE: 2F 01 00
acx: unknown EID 221 in mgmt frame at offset 81. IE: DD 06 00 10 18 02 00 05
acx: unknown EID 221 in mgmt frame at offset 89. IE: DD 18 00 50 F2 01 01 00 00 50 F2 02 01 00 00 50
F2 02 01 00 00 50 F2 02 00 00
scan table: SSID='IT-NETZWERK' CH=1 SIR=31 SNR=0
peer_cap 0x0411, needed_cap 0x0001
found station with matching ESSID! ('IT-NETZWERK' station, 'IT-NETZWERK' config)
matching station found: 00:14:BF:A5:74:99, joining
sending authentication1 request, awaiting response
acx_set_status(2):WAIT_AUTH
rates_basic:0003, rates_supported:1FFF
AUTHEN adev->addr=00:11:95:6F:A4:06 a1=00:11:95:6F:A4:06 a2=00:14:BF:A5:74:99 a3=00:14:BF:A5:74:99 adev->bssid=00:14:BF:A5:74:99
algorithm is ok
acx_process_authen auth seq step 2
acx_set_status(3):AUTHENTICATED
sending association request, awaiting response. NOT ASSOCIATED YET
association: requesting caps 0x0011, ESSID 'IT-NETZWERK'
wlan0: association FAILED: peer sent response code 12 (Assoc denied (reason outside of 802.11b scope), maybe MAC filtering by peer?)
BSS_Type = 2
JoinBSSID MAC:00:14:BF:A5:74:99
acx_i_timer: adev->status=3 (AUTHENTICATED)
resend assoc request (attempt 2)
sending association request, awaiting response. NOT ASSOCIATED YET
association: requesting caps 0x0011, ESSID 'IT-NETZWERK'
wlan0: association FAILED: peer sent response code 12 (Assoc denied (reason outside of 802.11b scope), maybe MAC filtering by peer?)
Jetzt habe ich auf dem Access-Point allerdings definitiv den MAC-Filter disabled und die Karte funktioniert unter Windows mit dem gleichen Access-Point ausgezeichnet.
In meine syslog funkt die Karte auch ständig diese Meldungen rein:
May 21 20:13:21 localhost kernel: acx_i_timer: adev->status=3 (AUTHENTICATED)
May 21 20:13:21 localhost kernel: resend assoc request (attempt 3)
May 21 20:13:21 localhost kernel: sending association request, awaiting response. NOT ASSOCIATED YET
May 21 20:13:21 localhost kernel: association: requesting caps 0x0011, ESSID 'IT-NETZWERK'
May 21 20:13:21 localhost kernel: wlan0: association FAILED: peer sent response code 12 (Assoc denie
d (reason outside of 802.11b scope), maybe MAC filtering by peer?)
Deswegen frage ich Euch, was ich noch falsch mache oder vergessen haben könnte?
Grüsse und vielen Dank
Imagine
ich habe auf meinem Laptop mit Debian Sarge eine WLAN-Karte D-Link DWL-G650+ installiert und zwar nach folgender Anleitung www.hauke-m.de/menue1/computer/acx100-acx111.html
Die Karte wird auch erkannt, iwconfig liefert
wlan0 IEEE 802.11b+/g+ ESSID:"IT-NETZWERK" Nickname:"acx v0.3.35"
Mode:Managed Frequency:2.412 GHz Access Point: Not-Associated
Bit Rate:1 Mb/s Tx-Power=15 dBm Sensitivity=1/3
Retry min limit:7 RTS thr:off
Encryption key:6147-3438-3477-7030-3400-0000-00 Security mode:open
Power Management:off
Link Quality=33/100 Signal level=6/100 Noise level=0/100
Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0
Tx excessive retries:0 Invalid misc:0 Missed beacon:0
In meiner /etc/network/interfaces steht folgender Eintrag drinnen
# The WLAN network interface (D-Link DWL-G650+)
auto wlan0
iface wlan0 inet dhcp
wireless-mode managed
wireless-keymode open
wireless-channel 1
wireless-essid IT-NETZWERK
wireless-key s:aG478ha098
dmesg liefert unter Anderem diese Meldungen
acx_i_timer: adev->status=3 (AUTHENTICATED)
association request reply timeout, giving up
acx_set_status(1):SCANNING
starting radio scan
acx: unknown EID 42 in mgmt frame at offset 69. IE: 2A 01 00
acx: unknown EID 47 in mgmt frame at offset 72. IE: 2F 01 00
acx: unknown EID 221 in mgmt frame at offset 81. IE: DD 06 00 10 18 02 00 05
acx: unknown EID 221 in mgmt frame at offset 89. IE: DD 18 00 50 F2 01 01 00 00 50 F2 02 01 00 00 50
F2 02 01 00 00 50 F2 02 00 00
acx: unknown EID 42 in mgmt frame at offset 69. IE: 2A 01 00
acx: unknown EID 47 in mgmt frame at offset 72. IE: 2F 01 00
acx: unknown EID 221 in mgmt frame at offset 81. IE: DD 06 00 10 18 02 00 05
acx: unknown EID 221 in mgmt frame at offset 89. IE: DD 18 00 50 F2 01 01 00 00 50 F2 02 01 00 00 50
F2 02 01 00 00 50 F2 02 00 00
scan table: SSID='IT-NETZWERK' CH=1 SIR=31 SNR=0
peer_cap 0x0411, needed_cap 0x0001
found station with matching ESSID! ('IT-NETZWERK' station, 'IT-NETZWERK' config)
matching station found: 00:14:BF:A5:74:99, joining
sending authentication1 request, awaiting response
acx_set_status(2):WAIT_AUTH
rates_basic:0003, rates_supported:1FFF
AUTHEN adev->addr=00:11:95:6F:A4:06 a1=00:11:95:6F:A4:06 a2=00:14:BF:A5:74:99 a3=00:14:BF:A5:74:99 adev->bssid=00:14:BF:A5:74:99
algorithm is ok
acx_process_authen auth seq step 2
acx_set_status(3):AUTHENTICATED
sending association request, awaiting response. NOT ASSOCIATED YET
association: requesting caps 0x0011, ESSID 'IT-NETZWERK'
wlan0: association FAILED: peer sent response code 12 (Assoc denied (reason outside of 802.11b scope), maybe MAC filtering by peer?)
BSS_Type = 2
JoinBSSID MAC:00:14:BF:A5:74:99
acx_i_timer: adev->status=3 (AUTHENTICATED)
resend assoc request (attempt 2)
sending association request, awaiting response. NOT ASSOCIATED YET
association: requesting caps 0x0011, ESSID 'IT-NETZWERK'
wlan0: association FAILED: peer sent response code 12 (Assoc denied (reason outside of 802.11b scope), maybe MAC filtering by peer?)
Jetzt habe ich auf dem Access-Point allerdings definitiv den MAC-Filter disabled und die Karte funktioniert unter Windows mit dem gleichen Access-Point ausgezeichnet.
In meine syslog funkt die Karte auch ständig diese Meldungen rein:
May 21 20:13:21 localhost kernel: acx_i_timer: adev->status=3 (AUTHENTICATED)
May 21 20:13:21 localhost kernel: resend assoc request (attempt 3)
May 21 20:13:21 localhost kernel: sending association request, awaiting response. NOT ASSOCIATED YET
May 21 20:13:21 localhost kernel: association: requesting caps 0x0011, ESSID 'IT-NETZWERK'
May 21 20:13:21 localhost kernel: wlan0: association FAILED: peer sent response code 12 (Assoc denie
d (reason outside of 802.11b scope), maybe MAC filtering by peer?)
Deswegen frage ich Euch, was ich noch falsch mache oder vergessen haben könnte?
Grüsse und vielen Dank
Imagine