16.08.00, 16:43
Hi,
ich habe hier eine APC Smart UPS600 über eine 9pol. RS232 Verbindung an einem Standard PC hängen. Das Kabel ist eines von APC selber (Typ 940-0024B). Die COM1-Schnittstelle liegt auf 3F8H mit dem IRQ4 (nix besonderes).
Weil die APC-Software einen Exclusivzugriff haben will, habe ich unter /etc/inittab die seriellen Ports so bearbeitet,
...
#1:123:respawn:/sbin/mingetty --noclear tty1
#2:123:respawn:/sbin/mingetty tty2
#3:123:respawn:/sbin/mingetty tty3
#4:123:respawn:/sbin/mingetty tty4
#5:123:respawn:/sbin/mingetty tty5
#6:123:respawn:/sbin/mingetty tty6
...
Als Software habe ich unter SuSe6.4 die APC Software von "http://www.apcc.com/tools/download/sw_kit.cfm?sku=sdw31" genauer "pc452_libc.tar" benutzt.
Beim Verbindungscheck kommt kurz vor Abschluss der Installation immer:
WARNING: Could not communicate with device on /dev/ttyS0.
Check that the communications cable is attached properly to both the device and the serial port.
Weiss jemand warum die Verbindung nicht klappt?
ich habe hier eine APC Smart UPS600 über eine 9pol. RS232 Verbindung an einem Standard PC hängen. Das Kabel ist eines von APC selber (Typ 940-0024B). Die COM1-Schnittstelle liegt auf 3F8H mit dem IRQ4 (nix besonderes).
Weil die APC-Software einen Exclusivzugriff haben will, habe ich unter /etc/inittab die seriellen Ports so bearbeitet,
...
#1:123:respawn:/sbin/mingetty --noclear tty1
#2:123:respawn:/sbin/mingetty tty2
#3:123:respawn:/sbin/mingetty tty3
#4:123:respawn:/sbin/mingetty tty4
#5:123:respawn:/sbin/mingetty tty5
#6:123:respawn:/sbin/mingetty tty6
...
Als Software habe ich unter SuSe6.4 die APC Software von "http://www.apcc.com/tools/download/sw_kit.cfm?sku=sdw31" genauer "pc452_libc.tar" benutzt.
Beim Verbindungscheck kommt kurz vor Abschluss der Installation immer:
WARNING: Could not communicate with device on /dev/ttyS0.
Check that the communications cable is attached properly to both the device and the serial port.
Weiss jemand warum die Verbindung nicht klappt?