BA53
26.09.04, 18:34
Hi,
also ich habe ein kleines Probelm mit der config von cpufreqd.
[General]
pidfile=/var/run/cpufreqd.pid
poll_interval=2
pm_type=acpi #(acpi, apm or pmu)
# Uncomment the following line to enable ACPI workaround (see cpufreqd.conf(5))
acpi_workaround=1
verbosity=4 #(if you want a minimal logging set to 5)
[Profile]
name=hi_boost
minfreq=1200000
maxfreq=1500000
policy=performance
[Profile]
name=lo_power
minfreq=600000
maxfreq=1500000
policy=powersave
# conservative mode when not AC
[Rule]
name=conservative
ac=off # (on/off)
#battery_interval=0-100
#cpu_interval=0-100
profile=lo_power
# full power when AC
[Rule]
name=AC_on
ac=on # (on/off)
profile=hi_boost
Also er soll wenn kein Netzkabel angeschlossen ist SpeedStep zwischen 600 MHz und max 1,5Gig fahren und wenn er dran hängt "full power" laufen.
Das funktioniert auch soweit mit der Umschaltung, aber wenn er über den Akku läuft, läuft er immer mit 600 Mhz egal was ich mache. Irgendwie schafft er es nicht, wenn er mehr belastet wird "einen Gang höher zu schalten".
Wäre super, wenn mir jemand helfen könnte.
Vielen Dank schonmal!
also ich habe ein kleines Probelm mit der config von cpufreqd.
[General]
pidfile=/var/run/cpufreqd.pid
poll_interval=2
pm_type=acpi #(acpi, apm or pmu)
# Uncomment the following line to enable ACPI workaround (see cpufreqd.conf(5))
acpi_workaround=1
verbosity=4 #(if you want a minimal logging set to 5)
[Profile]
name=hi_boost
minfreq=1200000
maxfreq=1500000
policy=performance
[Profile]
name=lo_power
minfreq=600000
maxfreq=1500000
policy=powersave
# conservative mode when not AC
[Rule]
name=conservative
ac=off # (on/off)
#battery_interval=0-100
#cpu_interval=0-100
profile=lo_power
# full power when AC
[Rule]
name=AC_on
ac=on # (on/off)
profile=hi_boost
Also er soll wenn kein Netzkabel angeschlossen ist SpeedStep zwischen 600 MHz und max 1,5Gig fahren und wenn er dran hängt "full power" laufen.
Das funktioniert auch soweit mit der Umschaltung, aber wenn er über den Akku läuft, läuft er immer mit 600 Mhz egal was ich mache. Irgendwie schafft er es nicht, wenn er mehr belastet wird "einen Gang höher zu schalten".
Wäre super, wenn mir jemand helfen könnte.
Vielen Dank schonmal!